Bent track from a backed-into bumper or a worn roller riding rough can pull a door clean off its rails. We fix the immediate problem and the root cause.
Every off-track call includes checking roller condition and bracket tightness alongside the track itself.
We don't eyeball alignment. Plumb and level get checked and confirmed before the job is done.
A bent section weakens over time even after straightening, so replacement is usually the more durable fix.
Full impact assessment covers track, brackets, and any panel damage from the same event.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
We realign horizontal and vertical track sections together, since a shift in one usually affects the other.
Visibly bent or dented track sections get swapped for new standard sections rather than bent back into shape.
A roller jumping the track repeatedly usually means the rollers themselves need replacing along with the fix.
Collision damage often affects more than the visible dent. We check the full track and frame mounting system.
A track can only stay aligned if the brackets holding it are solid. We check and correct this on every off-track call.
Let us know if the door is jammed off-track or just running rough, and we'll prioritize accordingly.
Most off-track calls don't require a parts run thanks to a well-stocked van.
A full inspection prevents a quick patch that fails again within weeks.
Track realigned or replaced, verified plumb, and tested through a full cycle before we leave.
“Backed the truck into the door and bent the track pretty badly. Replaced the section and it runs like new.”
“Track was off plumb by more than it looked. Fixed properly instead of a quick patch.”
“Appreciated that they checked the wall brackets too, not just the visible bent section.”
A combination of a worn roller and slightly bent track is one of the most common causes we see.
This is a job for a trained technician given the tension and alignment involved.
We'll assess the severity and recommend replacement when straightening won't hold up long-term.
Pricing varies with the extent of the damage, quoted upfront before any repair begins.
No, we recommend not operating the door until it's repaired, since further damage or injury risk increases with continued use.
A straightforward realignment often takes under an hour; a full section replacement may take a bit longer.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Roscoe to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Roscoe, TX